Clean' Brite
Concentrated Floor Cleaner and Brightener
No Rinsing Required
Lemon Scented
IDEAL FOR ALL FLOORS: Terrazzo - Tile - Marble - Magnesite - Cement - Masonry - Vinyl Tile -
Exposed Aggregate - Marble Crete - Brick - and Today's no wax Floors
- Excellent for large area and small floor maintenance
- Clean' Brite is excellent for high speed floor care; use 6 oz per gallon of cold tap water, damp mop and allow
Clean' Brite to air dry, then high speed burnish to a dramatic brighter "wet look" finish.
- Clean' Brite is excellent for use in commercial automatic floor scrubbing machines.
- Clean' Brite contains a special blend of several non-ionic surfactant cleaners which can NOT leave a film on
the floor. Optical brighteners, Fragrance and stabilizers are also contained to ensure freshness and gloss,
Contains no Phosphorus.
Crystal Seal Penetrating Sealer
- Crystal Clear, Colorless, non yellowing
- Use on white or other cements
- Outdoor or indoor
- Dries in 30 minutes
- Acrylic Base
- Penetrates thoroughly
- No Lap marks
- No buffing needed
- Easy to apply by brush, dip or spray
Crystal Cote
- Crystal Clear and Colorless
- Use on white or other cements
- Outdoor or indoor
- Dries in 60 minutes
- Acrylic Base
- No Lap marks
- No buffing needed
- Easy to apply by brush, dip or spray
Key Acrylic Sealer
- Clear acrylic solution formulated to create a clear, non yellowing protective coating
- Provides a tough, UV and abrasion resistant film that effectively protects surfaces from moisture penetration,
staining, dirt, dust and wear
- Provides a surface that is easy to clean and maintain
- Interior or exterior application
Key Acrylic Sealer is most commonly used as a sealer for Epoxy Terrazzo and Polymeric Terrazzo
flooring systems. It is used for sealing old and new concrete floors, exterior ramps, decks, sidewalks, slate and
exposed aggregate surfaces.
- UV Resistant
- Excellent Clarity and Color Retention
- Low Maintenance Finish
- Excellent Abrasion and Mar Resistance
- Seals Substrate from Moisture Penetration
*Do not apply below 50 degrees F
*Contains solvent - Keep from ignition sources
*Must be applied with proper ventilation